1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications & Procedures: Adjustments: Toe-In

  1. Loosen jam nuts at tie rod ends, and release clips at small ends of steering gear boots. Be sure boots are free on tie rods so that they will not be twisted when tie rods are turned.
  2. Turn tie rods into or out of the tie rod ends an equal amount on each side, keeping steering wheel centered. Since steering gear and tie rod connections are forward of front wheel spindles, the tie rods must be shortened. Screw tie rod ends inward to increase toe-in length.
  3. When toe-in is correct, tighten tie rod end jam nuts to 42-50 ft. lb. (57-68 N.m.). Verify that steering gear boot ends are positioned in the reduced diameter sections of the tie rods and install the boot clips.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.