1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE

Calibration Number Identification: Notes

To identify the engine calibration number, locate the engine code label at the front of the engine. Although there are several label styles, the engine calibration number is shown on each. See Fig 1. Calibration codes will begin with a number indicating the current model year. For example, calibrations listed for 1986 Ford vacuum diagrams begin with "6". Each vehicle is also equipped with an emission control data decal applying to that vehicle and its engine. See Fig 2. These decals are usually located on the underside of the hood, or other visible engine compartment location.

Fig 1: Engine Calibration Code Label Styles
G13820
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.