Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
In-Line Fuse Check
- Disconnect negative battery cable. Remove relay panel cover and carefully spread sides of panel box to disengage lock tabs. Pull panel out of box. Fuse is located in holder on underside of panel. Replace fuse if blown.
- If fuse is not blown and pumps do not run, remove fuse from holder and connect jumper wire from alternator output terminal to 1 wire of fuse holder. If pumps still do not operate, move jumper wire to other wire in fuse holder. If pumps still do not operate, check electrical circuit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
