1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE

Inertia Switch Test

  1. Turn ignition switch to "RUN" position. Using a test light, check for battery voltage at both inertia switch wires. If light comes on at both wires, switch is okay. Go to IN-LINE FUSE TESTΒ  .
  2. If light does not come on at either wire, check for open circuit. If light comes on one wire, replace inertia switch and retest system. See Fig 1 and Fig 2 .
Fig 1: Resetting Inertia Switch
G35454
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.