Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Mercury Milan Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications Table
TORQUE SPECIFICATIONS TABLE
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Ground wire nut - 2.5L | 18 | - | 159 |
| Ground wire nut - 3.0L | 18 | - | 159 |
| Starter motor bolt and stud bolt (2.5L) | 25 | 18 | - |
| Starter motor bolts (3.5L) | 27 | 20 | - |
| Starter motor solenoid battery cable nut | 12 | - | 106 |
| Starter motor solenoid wire nut | 5 | - | 44 |
| Starter motor stud bolts (3.0L) | 27 | 20 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
