Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE
Selector Lever Bezel: Notes
| Item | Part Number | Description |
|---|---|---|
| 1 | 54061A16 | Gear indicator trim ring |
| 2 | 54045A76 | Center console trim cover |
| 3 | - | Lower selector lever knob bezel (part of 7L010) |
| 4 | - | Selector lever knob screw (part of 7L010) |
| 5 | 7L010 | Selector lever knob |
| 6 | 7E034 | Selector lever bezel |
| 7 | - | Selector lever bezel light |
| 8 | 14A459 | Transmission control (TC) switch electrical connector |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.