Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Inner tie rod | 110 | 81 | - |
| Power steering control valve actuator bolt | 16 | - | 142 |
| Power steering fluid cooler bolts | 9 | - | 80 |
| Power steering line clamp plate bolt | 23 | 17 | - |
| Power steering pressure line bracket-to-engine bolt | 9 | - | 80 |
| Power steering pressure line bracket-to-rear engine bolt | 9 | - | 80 |
| Power steering pressure line bracket-to-steering gear bolt | 23 | 17 | - |
| Power steering pressure line bracket-to-valve cover stud nut | 9 | - | 80 |
| Power steering pressure line fitting-to-power steering pump | 65 | 48 | - |
| Power steering pump bolts | 25 | 18 | - |
| Power steering return line bracket-to-frame bolts | 5 | - | 44 |
| Roll resistor bracket-to-transaxle nut | 48 | 35 | - |
| Stabilizer bar bracket bolts | 50 | 37 | - |
| Stabilizer bar link upper nuts | 55 | 41 | - |
| Steering column shaft-to-steering gear bolt | 25 | 18 | - |
| Steering effort control module (SECM) nuts | 9 | - | 80 |
| Steering gear nuts | 117 | 86 | - |
| Tie-rod end nuts | 115 | 85 | - |
| Tie-rod jam nuts | 55 | 41 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
