2009 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE

Engine Ignition Components - Exploded View

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Engine Ignition Components - LH Side With Torque Specifications
GF0046720Courtesy of FORD MOTOR CO.
Item Part Number Description
1 14A464 Ignition coil-on-plug electrical connector (4 required)
2 W706175 Ignition coil-to-intake manifold bolt (4 required)
3 12A366 Ignition coil (4 required)
4 12405 Spark plug (4 required)
Fig 2: Exploded View Of Engine Ignition Components - RH Side With Torque Specifications
GF0046721Courtesy of FORD MOTOR CO.
Item Part Number Description
5 14A464 Ignition coil-on-plug electrical connector (4 required)
6 W706175 Ignition coil-to-intake manifold bolt (4 required)
7 12A366 Ignition coil (4 required)
8 12405 Spark plug (4 required)
  1. For additional information, refer to the appropriate procedures in this article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.