2009 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
Anti-Theft Hood Switch Left front corner of engine compartment. See Figure.
Brake Fluid Level Switch Left rear of engine compartment. See Figure.
Brake Pedal Position (BPP) Switch Left side of dash. See Figure.
Door Ajar Switch (Left Front) Driver's door. See Figure.
Door Ajar Switch (Left Rear) Left rear door. See Figure.
Door Ajar Switch (Right Front) Front passenger's door. See Figure.
Door Ajar Switch (Right Rear) Right rear door. See Figure.
Inertia Fuel Shutoff (IFS) Switch Right kick panel. See Figure.
Oil Pressure Switch Left front of engine block. See Figure.
Parking Brake Switch Left kick panel. See Figure.
Power Steering Pressure Switch Right front of engine. See Figure.
Safety Belt Buckle Switch (Driver) Under driver's seat. See Figure.
Safety Belt Buckle Switch (Passenger) Under front passenger's seat. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.