2009 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
Air Bag Module (Driver) Steering wheel assembly. See Figure.
Air Bag Module (Passenger) Right side of dash. See Figure.
Blower Motor Resistor Right side of HVAC unit. See Figure.
Blower Motor Resistor (Auxiliary) Left rear corner of vehicle. See Figure.
Clockspring Steering wheel assembly. See Figure.
Coil On Plug (COP) 1 Top of right cylinder head. See Figure.
Coil On Plug (COP) 2 Top of right cylinder head. See Figure.
Coil On Plug (COP) 3 Top of right cylinder head. See Figure.
Coil On Plug (COP) 4 Top of left cylinder head. See Figure.
Coil On Plug (COP) 5 Top of left cylinder head. See Figure.
Coil On Plug (COP) 6 Top of left cylinder head. See Figure.
Data Link Connector (DLC) Below steering column. See Figure.
Electronic Hidden Antenna Module (EHAM) (Sable & Taurus) Base of right "C" pillar. See Figure.
Electronic Hidden Antenna Module (EHAM) (Taurus X) Top right of liftgate. See Figure.
Horn Center of front bumper. See Figure.
Parking Aid Speaker (Sable & Taurus) Left rear of luggage compartment. See Figure.
Parking Aid Speaker (Taurus X) Top of right "C" pillar. See Figure.
Safety Belt Load Limiting Retractor (Driver) Base of left "B" pillar. See Figure.
Safety Belt Load Limiting Retractor (Passenger) Base of right "B" pillar. See Figure.
Safety Canopy Module (Driver) (Sable & Taurus) Left "C" pillar. See Figure.
Safety Canopy Module (Driver) (Taurus X) Top of left "D" pillar. See Figure.
Safety Canopy Module (Passenger) (Sable & Taurus) Right "C" pillar. See Figure.
Safety Canopy Module (Passenger) (Taurus X) Top of right "D" pillar. See Figure.
Side Air Bag Module (Driver) Under driver's seat. See Figure.
Side Air Bag Module (Passenger) Under front passenger's seat. See Figure.
Subwoofer Amplifier (Sable & Taurus) Left side of luggage compartment. See Figure.
Subwoofer Amplifier (Taurus X) Right rear quarterpanel. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.