Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accessory Protocol Interface Module (APIM) Programming
APIM programming is a process which updates the APIM consumer interface processor (CIP) and vehicle interface processor (VIP) software. The VIP programming updates the calibration files in the portion of the APIM which interfaces with the controller area network (CAN). The CIP programming updates calibration files in the portion of the APIM which interfaces with mobile phones and other customer devices.
APIM programming uses the vehicle communication module (VCM) to read and program the VIP software through the DLC. A web-based OASIS application is used to read and program the CIP software via a universal serial bus (USB) cable between the scan tool and vehicle USB port. Both the VCM and OASIS application must be running on the scan tool during APIM programming.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.