2008 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G100 Right front of engine compartment. See Figure.
G101 Left front of engine compartment. See Figure.
G102 Right rear side of engine compartment. See Figure.
G103 Left front of engine compartment. See Figure.
G104 (Sable) Right rear of engine. See Figure.
G104 (Taurus) Right rear of engine. See Figure.
G104 (Taurus X) Right rear of engine. See Figure.
G200 Under center console. See Figure.
G202 Under center console. See Figure.
G210 Behind left kick panel. See Figure.
G300 At base of right "C" pillar. See Figure.
G302 (Sable & Taurus) At base of left "C" pillar.
G302 (Taurus X) At base of left "C" pillar. See Figure.
G305 (Sable & Taurus) At base of right "C" pillar. See Figure.
G400 (Sable & Taurus) At base of left "C" pillar.
G400 (Taurus X) Right rear corner of vehicle. See Figure.
G401 (Sable & Taurus) At base of left "C" pillar.
G401 (Taurus X) Right rear corner of vehicle. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.