Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mercury Sable Base, FWDFACTORY OEM SERVICE PROCEDURE
Engine Mechanical: Mechanical: Engine: Disassembly: Engine
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| 3-Jaw Puller | 303-D121 | |
| Camshaft Alignment Tool | 303-1248 | |
| Handle | 205-153 (T80T-4000-W) | |
| Remover, Crankshaft Rear Oil Seal | 303-519 (T95P-6701-EH) | |
| Remover, Oil Seal | 303-409 (T92C-6700CH) | |
| Remover, Seal | 303-1247/1 | |
| Slide Hammer | 307-005 (T59L-100-B) | |
| Strap Wrench | 303-D055 (D85L-6000-A) |
Material
| Item | Specification |
|---|---|
| Motorcraft Metal Surface Prep ZC-31-A |
- |
| Silicone Gasket Remover ZC-30 |
- |
CAUTION:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.