Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mercury MontereyFACTORY OEM SERVICE PROCEDURE
Component testing procedure
WARNING: This page is about a different car, the 2007 Mercury Montego and 2007 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
MULTIFUNCTION SWITCH, WIPER/WASHER PORTION - COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Washer switch circuit | 5 and 2 | Washer switch depressed | Closed circuit |
| Wiper switch circuit | 4 and 2 | Off | Open circuit |
| High | Closed circuit | ||
| Low | Open circuit | ||
| 6 and 2 | Off | Open circuit | |
| High | Closed circuit | ||
| Low | Closed circuit | ||
| 12 and 2 | Off | Open circuit | |
| High | Closed circuit | ||
| Low | Closed circuit |
MULTIFUNCTION SWITCH, WIPER/WASHER PORTION - COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Wiper switch circuit (rear wiper) | 8 and 7 | Interval 1 | Closed circuit |
| 10 and 7 | Open circuit | ||
| 8 and 7 | Interval 2 | Closed circuit | |
| 10 and 7 | Closed circuit | ||
| Intermittent wiper circuit | 1 and 2 | Interval 1 | Open circuit |
| Interval 2 | Closed circuit | ||
| Interval 3 | Closed circuit | ||
| Interval 4 | Closed circuit | ||
| Interval 5 | Open circuit | ||
| 6 and 2 | Interval 1 | Closed circuit | |
| Interval 2 | Closed circuit | ||
| Interval 3 | Open circuit | ||
| Interval 4 | Open circuit | ||
| Interval 5 | Open circuit | ||
| 12 and 2 | Interval 1 | Open circuit | |
| Interval 2 | Open circuit | ||
| Interval 3 | Open circuit | ||
| Interval 4 | Closed circuit | ||
| Interval 5 | Closed circuit | ||
| Mist Circuit | 6 and 2, 12 and 2 | Mist | Closed circuit |
| Mist Circuit (rear wiper) | 8 and 7 | Rear washer | Open circuit |
| 10 and 7 | Rear washer | Closed circuit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.