2007 Mercury MontereyFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the 2 retaining nuts.
    • Tighten to 5 Nm (44 lb-in).
  2. Connect the PCM electrical connector and tighten the bolt.
    • Tighten to 7 Nm (62 lb-in).
  3. Position the power steering reservoir and install the bolt.
    • Tighten to 10 Nm (89 lb-in).
  4. Position the suction accumulator and install the 3 bolts.
    • Tighten to 5 Nm (44 lb-in).
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.