2007 Mercury MontereyFACTORY OEM SERVICE PROCEDURE

Disassembly And Assembly Of Subassemblies: Piston: Disassembly

  1. Using the special tool, press the piston pin out from the connecting rod and piston assembly.
  2. Fig 1: Pressing Piston Pin From Connecting Rod Using Special Tool (303--S024)
    GF0033189Courtesy of FORD MOTOR CO.
  3. Remove the connecting rod from the piston.
  4. Fig 2: Removing Connecting Rod From Piston
    GF0002548Courtesy of FORD MOTOR CO.
  5. Clean and inspect the connecting rod and piston. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.