2007 Mercury MontereyFACTORY OEM SERVICE PROCEDURE

Inspection and Verification

This section provides step-by-step module configuration procedures. Carry out the PMI procedures in this article when another workshop manual section directs to carry out configuration or when DTCs from the below list are present:

DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B2477 Module Configuration Failure
  • Anti-lock brake system (ABS) module
  • Climate controlled seat module
  • Electronic automatic temperature control (EATC)
  • Driver seat module (DSM)
  • Smart junction box (SJB)
  • Instrument cluster
  • Restraints control module (RCM)
  • Parking aid module
CARRY OUT PMI. REFER to Programmable Module Installation .
P0602 Powertrain Control Module Programming Error
  • Powertrain control module (PCM)
CARRY OUT PMI. REFER to Programmable Module Installation .
P0605 Internal Control Module Read Only Memory (ROM) Error
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U0300 Internal Control Module Software Incompatibility
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U0301 Software Incompatibility with Engine/Powertrain Control Module
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U2050 No Application Present
  • ABS module
  • Instrument cluster
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U2051 One or More Calibration Files Missing / Corrupt
  • ABS module
  • PCM
  • Parking aid module
CARRY OUT PMI. REFER to Programmable Module Installation .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.