2007 Mercury Montego Base, AWDFACTORY OEM SERVICE PROCEDURE

Engine Mechanical: Mechanical: Engine: Installation: Engine

Special Tools

Illustration Tool Name Tool Number
GF0016982
Lifting Brackets, Engine 134-00243 or equivalent
GF0017081
Powertrain Lift with Tilting Plate 014-00765
GF0000267
Spreader Bar 303-D089 (D93P-6001-A3) or equivalent
GF0016983
Engine Lifting Bracket Set 303-1140
Material

Item Specification
Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil
XO-5W20-QSP (US); Motorcraft SAE 5W-20 Super Premium Motor Oil CXO-5W20-LSP12 (Canada); or equivalent
WSS-M2C930-A
Threadlock and Sealer
TA-25
WSK-M2G351-A5
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.

All vehicles 

  1. Using the special tools and a suitable engine crane, align the engine with the transaxle.
  2. Fig 1: Aligning Engine With Transaxle
    GF0017201Courtesy of FORD MOTOR CO.

    Vehicles with 6-speed transaxle 

  3. Install the 4 transaxle-to-engine bolts.
    • Tighten to 40 Nm (30 lb-ft).
  4. Fig 2: Locating Transaxle-To-Engine Bolts
    GF0017131Courtesy of FORD MOTOR CO.

    Vehicles with CVT transaxle 

  5. Install the 3 transaxle-to-engine bolts.
    • Tighten to 40 Nm (30 lb-ft).
  6. Fig 3: Identifying Transaxle-To-Engine Bolts
    G03990288Courtesy of FORD MOTOR CO.

    All vehicles 

  7. Install the engine-to-transaxle bolt.
    • Tighten to 40 Nm (30 lb-ft).
  8. Fig 4: Locating Knock Sensor
    G03990667Courtesy of FORD MOTOR CO.
  9. Position the knock sensor (KS), install the bolt and connect the electrical connector.
    • Tighten to 20 Nm (15 lb-ft).
  10. Fig 5: Locating Knock Sensor (KS) Electrical Connector & Bolt
    GF0017202Courtesy of FORD MOTOR CO.
  11. Attach the heat shield to the KS.
  12. Fig 6: Identifying Knock Sensor Heat Shield
    G03990937Courtesy of FORD MOTOR CO.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.