2007 Mercury Montego Base, AWDFACTORY OEM SERVICE PROCEDURE

Inspection and Verification

This section provides step-by-step module configuration procedures. Carry out the PMI procedures in this article when another workshop manual section directs to carry out "configuration" or when DTCs from the below list are present:

DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B2477 Module Configuration Failure Anti-lock brake module (ABS)
Audio unit
Driver seat module (DSM)
Smart junction box (SJB)
Instrument cluster
Parking aid module
Satellite digital audio radio system (SDARS)
CARRY OUT programmable module installation (PMI). REFER to Programmable Module Installation .
B2900 VIN Mismatch ABS module CARRY OUT PMI. REFER to Programmable Module Installation .
P0602 Powertrain Control Module Programming Error Powertrain control module (PCM) CARRY OUT PMI. REFER to Programmable Module Installation .
P0605 Internal Control Module Read Only Memory (ROM) Error PCM
Transmission control module (TCM)
CARRY OUT PMI. REFER to Programmable Module Installation .
P1639 Vehicle ID Block Corrupted, Not Programmed PCM CARRY OUT PMI. REFER to Programmable Module Installation .
U0300 Internal Control Module Software Incompatibility PCM CARRY OUT PMI. REFER to Programmable Module Installation .
U0301 Software Incompatibility with Engine/Powertrain Control Module PCM
TCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U2050 No Application Present ABS module
Audio unit
Electronic automatic temperature control (EATC)
Differential electronic module (DEM)
DSM
SJB
Instrument cluster
PCM
Restraint control module (RCM)
SDARS
TCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U2051 One or More Calibration Files Missing / Corrupt Audio unit
PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.