2005 Mercury MontereyFACTORY OEM SERVICE PROCEDURE

Acceleration Control

The throttle is controlled by the accelerator cable which is connected to the accelerator pedal and shaft.

  • The accelerator pedal and shaft should travel smoothly from the idle to the wide-open throttle (WOT) positions. Hesitation on return or prevention of return to the idle position must not occur.
  • Surrounding components such as wiring, hoses, sound insulator and floor covering must not contact the sliding inner member of the accelerator cable or the accelerator pedal and shaft.
  • The sliding inner member of the accelerator cable should not be lubricated and is not serviceable.

Some vehicles are equipped with adjustable brake and accelerator pedals. The adjustable brake and accelerator pedals and the fixed brake and accelerator pedals are serviced as an assembly. For additional information on diagnosing and servicing this component, refer to HYDRAULIC BRAKE ACTUATION .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.