2005 Mercury Montego Base, FWDFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the bolt.
    • Tighten to 8 Nm (71 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Install the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS .
  7. Carry out the Transaxle Drive Cycle Test. For additional information, refer to AUTOMATIC TRANSAXLE - 6 SPEED .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.