2005 Mercury Montego Base, FWDFACTORY OEM SERVICE PROCEDURE

Removal and Installation

    All vehicles 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Five Hundred 

  3. Remove the rear seat cushion and the rear corner backrest. For additional information, refer to SEATING .
  4. Freestyle 

  5. Remove the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  6. All vehicles 

  7. Disconnect the fuel pump driver module (FPDM) electrical connector.
  8. Remove the 2 nuts and the FPDM.
    • To install, tighten to 5 Nm (44 lb-in).
  9. To install reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.