2004 Mercury MontereyFACTORY OEM SERVICE PROCEDURE

Engine Mount: Notes

Special Tool(s) 

Fig 1: Identifying Special Tool(s)
G03243922Courtesy of FORD MOTOR CO.
  1. If removing the RH, LH or rear engine mount, the vehicle must be lifted on a hoist during this procedure. With the vehicle in neutral, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. If removing the RH, LH or rear engine mount, remove the hood.
  3. If removing the RH, LH or rear engine mount, remove the wiper motor and pivot assembly. For additional information, refer to WINDSHIELD WIPER .
  4. Remove the parts in the order indicated in the following illustrations.

    To remove individual parts, only carry out the listed steps: 

    Part Steps
    Engine roll restrictor 1-2
    Rear engine mount 1-7
    RH engine mount 1-5, 8-9
    LH engine mount 1-5, 10-12
    Fig 2: Engine Mount Parts Removal Sequence (Items 1-9)
    G03243923Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.