2003 Mercury MarauderFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System (ABS) Module

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.

The ABS Module is on the SCP communication network. The ABS module controls the brake pressure to the four wheels to keep the vehicle under control while braking. The ABS module also controls the stability assist and traction control systems (if equipped). If one of the bus wires becomes shorted to ground or voltage, or if some but not all termination resistors are lost, communications can continue at a degraded level. Check the SCP circuits 915 (PK/LB) and 914 (TO/OG) between the ABS module C155 and the DLC C251. Total resistance values must not be more than 5 ohms. If the resistance is more than 5 ohms, there is an open circuit in the SCP network, damage to the DLC C251, damage to the ABS module C155, or a problem in the in-line connector. For additional information, refer to ANTI-LOCK CONTROL .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.