2002 Mercury Villager BaseFACTORY OEM SERVICE PROCEDURE

Main Control - Valve Body: Installation

    CAUTION: Use the 43.5 mm (1.74 in) long bolts for this step or damage to the transaxle case or valve body may occur.
  1. Install main control valve body.
    1. Feed the wiring harness through the transaxle case.
    2. Install the 43.5 mm (1.74 in) long main control valve body bolts.
      Fig 1: Installing Main Control Valve Body
      G03412244Courtesy of FORD MOTOR CO.
  2. CAUTION: Use the 33 mm (1.32 in) long bolts for this step or damage to the transaxle case or valve body may occur.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.