2002 Mercury Villager BaseFACTORY OEM SERVICE PROCEDURE

Transaxle Electronic Control System: Inputs

The following are electronic control system inputs:

  • Throttle position sensor (TPS)
  • Engine speed (RPM)
  • Digital transmission range (TR) switch
  • Vehicle speed sensor (VSS)
  • Overdrive (O/D) control switch
  • Transmission fluid temperature (TFT) sensor
  • Output shaft speed (OSS) sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.