Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Aids
Perform this test only when directed by QUICK TEST. This test is intended to diagnose the following:
- Throttle Position (TP) sensor.
- Binding and sticking throttle
- Harness circuits; SIG RTN, TP SIG and VREF.
- PCM.
For DTC P0120, TP PID should read approximately 80 percent with throttle valve fully open. With throttle valve fully closed, TP PID should read zero percent.
| Throttle Position | (1) Voltage | ||
|---|---|---|---|
| Closed | .4 | ||
| 1/4 | 1.3 | ||
| Half Open | 2.2 | ||
| 3/4 | 3.1 | ||
| Fully Open | 4.1 | ||
|
|||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
