2002 Mercury Sable LS, 4D WagonFACTORY OEM SERVICE PROCEDURE

Removal & Installation

WARNING: This page is about a different car, the 2002 Mercury Grand Marquis and 2002 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Remove driver's side underdash panel pin retainers. Disconnect courtesy lamp harness connector. See STEP 1 in Fig 1. Locate Lighting Control Module (LCM) above accelerator pedal. If vehicle is equipped with adjustable pedals, remove accelerator pedal. See FIXED & ADJUSTABLE ACCELERATOR PEDALΒ  under REMOVAL & INSTALLATION. Remove LCM holding bracket screws. Unclip module from mounting bracket. See STEP 2 in Fig 1. Disconnect LCM harness connectors. See STEP 3 in Fig 1. To install, reverse removal procedure.

Fig 1: Removing & Installing Lighting Control Module
G00191619Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.