2002 Mercury Sable LS, 4D WagonFACTORY OEM SERVICE PROCEDURE

Programmable Module Installation

WARNING: This page is about a different car, the 2002 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Programmable Module Installation (PMI) method is used when a new programmable module is installed. Worldwide Diagnostic System (WDS) tester or New Generation Star (NGS) tester automatically obtains any valuable module option content information from old module during vehicle ID routine that runs when diagnostic tool tester is initially connected to vehicle. It is important to connect diagnostic tool tester to Data Link Connector (DLC). See Figure. DLC is located under instrument panel between steering column and the radio. See Figure. Allow it to identify the vehicle and obtain configuration data prior to removing any module.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.