2002 Mercury Sable LS PremiumFACTORY OEM SERVICE PROCEDURE

Piston - Selection

NOTE: The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
  1. Select a piston size based on the cylinder bore.
    Fig 1: Identifying Piston Bore Measurement
    G02156254Courtesy of FORD MOTOR CO.
  2. NOTE: For precision fit, new pistons are divided into three categories within each size range based on their relative position within the range. A paint spot on the new pistons indicates the position within the size range.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.