Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver's Door Module
Before replacing Driver's Door Module (DDM), module configuration information must be uploaded to Worldwide Diagnostic System (WDS) tester, New Generation Star (NGS) tester or other compatible scan tool. For reprogramming assistance, see CONTROL MODULE PROGRAMMING under FORD MOTOR CO. in COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. New DDM must be programmed with this configuration information.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.