2002 Mercury Sable LS PremiumFACTORY OEM SERVICE PROCEDURE

ABS Control Module Diagnostic Trouble Code (DTC) Index

NOTE: The wheel speed DTCs can be cleared but the warning indicator will remain illuminated until the vehicle is driven over 12 km/h (7 mph).
ABS CONTROL MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC Description Source Action
B1318 Battery Voltage Low ABS/TC Go To PINPOINT TEST C .
B1342 ABS Module Internal Failure ABS/TC CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new electronic control unit (ECU). REPEAT the self-test.
B1484 Brake Pedal Input Open Circuit ABS/TC Go To PINPOINT TEST D .
B1596 Repair Continuous Codes ABS/TC REPAIR DTCs retrieved. CLEAR the DTCs. CYCLE the ignition once. REPEAT the self-test.
C1095 ABS Hydraulic Pump Motor Circuit Failure ABS/TC Go To PINPOINT TEST E .
C1145 RF Wheel Speed Sensor Input Circuit Failure ABS/TC Go To PINPOINT TEST F .
C1155 LF Wheel Speed Sensor Input Circuit Failure ABS/TC Go To PINPOINT TEST F .
C1165 RR Wheel Speed Sensor Input Circuit Failure ABS/TC Go To PINPOINT TEST F .
C1175 LR Wheel Speed Sensor Input Circuit Failure ABS/TC Go To PINPOINT TEST F .
C1222 Wheel Speed Signal Mismatch ABS/TC Go To PINPOINT TEST G .
C1233 LF Wheel Speed Input Signal Missing ABS/TC Go To PINPOINT TEST H .
C1234 RF Wheel Speed Input Signal Missing ABS/TC Go To PINPOINT TEST H .
C1235 RR Wheel Speed Input Signal Missing ABS/TC Go To PINPOINT TEST H .
C1236 LR Wheel Speed Input Signal Missing ABS/TC Go To PINPOINT TEST H .
C1266 ABS Valve Power Relay Circuit Failure ABS/TC Install a new Electronic Control Unit (ECU). Repeat the self-test.
U1009 SCP Invalid or Missing Data for Engine Torque PCM CARRY OUT the PCM self-test.
U1262 SCP Communication Bus Fault SCP Network REFER to MODULE COMMUNUCATIONS NETWORK .
C1805 Mismatched Powertrain Control Module (PCM) and/or ABS module ABS/TC CARRY OUT the PCM self-test. CHECK for correct PCM and ABS module part numbers
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.