SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2001VILLAGER BASEREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSREMOTE KEYLESS ENTRY SYSTEMSPROGRAMMINGREMOTE TRANSMITTER
2001 Mercury Villager Base

Remote Transmitter

2001 Mercury Villager BaseSECTION Remote Transmitter
  1. Enter vehicle. Ensure all doors are closed and locked. Insert and remove key from ignition switch more than 6 times within 10 seconds to erase old remote transmitter code. Instrument panel lights will flash to indicate programming mode has been entered.
  2. Turn key to accessory position. This will erase all previous codes. Press any button on remote transmitter once. Parking lights will flash twice to indicate new code is accepted. To program an additional remote transmitter, unlock then lock driver's door using interior master door lock switch. Press any button on additional remote transmitter(s). Parking lights will flash twice to indicate new code is accepted. Open front door to exit programming. Parking lights will flash twice to confirm exiting programming mode. Up to 4 remote transmitters can be programed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.