SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2001VILLAGER BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICSQUICK TESTDIAGNOSTIC TEST MODE
2001 Mercury Villager Base

Diagnostic Test Mode

2001 Mercury Villager BaseSECTION Diagnostic Test Mode
  1. Ensure engine is warmed to normal operating temperature. If engine does not start, continue with testing. Turn ignition on. Ensure test equipment is properly attached.
  2. Using New Generation Star (NGS) tester, select and enter the following data:
    • Select vehicle and engine selection menu.
    • Select year, engine, model and any additional information requested by NGS tester.
    • Select DIAGNOSTIC DATA LINK.
    • Select PCM-POWERTRAIN CTRL MODULE.
    • Select DIAGNOSTIC TEST MODE RESULTS.
  3. At this point, scan tool should display all DTCs. Write down codes in order displayed. If a communication problem exists between NGS tester and PCM, see COMMUNICATION ERROR  under SELF-DIAGNOSTICS USING SCAN TOOL.
    NOTE: If a DTC is retrieved during QUICK TEST, PCM may have stored PID data. See FREEZE FRAME DATA MODE  under ADDITIONAL SYSTEM FEATURES. If desired, check freeze frame data before clearing codes. Clearing codes will erase freeze frame data.
  4. To determine if codes will reappear, indicating a hard (non-intermittent) fault, clear codes and recheck for codes. See CLEARING CODES . If DTC immediately returns, malfunction is considered to be a hard fault. If a DTC does not immediately return, vehicle may need to be driven in a special pattern to cause code to reset. See DRIVE CYCLES .
  5. If one or more DTCs were retrieved in previous procedure, see SCAN TOOL CODE DIRECTORY  table to identify test to perform. Service DTCs in same order displayed by scan tool. If no DTCs or Code P0000 (pass code) were retrieved, proceed to TROUBLE SHOOTING - NO CODES - VILLAGER article.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.