Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Freeze Frame Data Mode
This mode allows access to data values captured during a malfunction that caused a DTC to set. These values are immediately stored in continuous memory when an emission related fault occurs. This provides a snapshot of conditions present when fault occurred. Freeze frame data will be stored until PCM memory is erased. Misfire fault data may override less important fault data.
To access FREEZE FRAME DATA MODE, turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:
- Select year, engine, model and any additional information requested by scan tool (optional).
- Follow operating instructions from scan tool menu.
- Select DIAGNOSTIC FUNCTIONS. Press CONT button if OBD-II System Readiness Tests (SRT) are not complete.
- Turn ignition on.
- Select FREEZE FRAME PID REQUEST.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.