2000 Mercury Villager BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Compressor Cycling Switch On right side of engine compartment. See Figure.
Brake Fluid Level Switch On brake fluid reservoir. See Figure.
Brake Pedal Position (BPP) Switch On bracket, above brake pedal. See Figure.
Deactivator Switch Behind left side of dash, top of brake pedal support. See Figure.
Dual Pressure Switch In right front of engine compartment. See Figure.
Inertia Fuel Shut-Off Switch Behind left side of dash, above kick panel. See Figure.
Oil Pressure Switch On right front side of engine.
Park Brake Switch On bracket, above parking brake pedal. See Figure.
Power Steering Pressure (PSP) Switch On high pressure power steering line, on right rear of engine compartment.
Seat Belt Switch On driver's seat belt buckle.
Throttle Position Switch On throttle body. See Figure.
Washer Fluid Level Switch In right front side of engine compartment, on washer fluid reservoir. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.