2000 Mercury Villager BaseFACTORY OEM SERVICE PROCEDURE

Parameter Identification & Definitions

PID DEFINITIONS (ABS CONTROL MODULE)

PID Description Expected Value
ABSLF_O Left Front ABS Outlet Valve ON, OFF
ABSRF_O Right Front ABS Outlet Valve ON, OFF
ABSRR_O Right Rear ABS Outlet Valve ON, OFF
ABSLR_O Left Rear ABS Outlet Valve ON, OFF
ABSLF_I Left Front ABS Inlet Valve ON, OFF
ABSRF_I Right Front ABS Inlet Valve ON, OFF
ABSRR_I Right Rear ABS Inlet Valve ON, OFF
ABSLR_I Left Rear ABS Inlet Valve ON, OFF
LF_WSPD Left Front Wheel Speed Signal 0-255 MPH
RF_WSPD Right Front Wheel Speed Signal 0-255 MPH
RR_WSPD Right Rear Wheel Speed Signal 0-255 MPH
LR_WSPD Left Rear Wheel Speed Signal 0-255 MPH
PWRSUP Battery Voltage To Anti-Lock Control Module #.## V
ABSLAMP ABS Warning Light State OFF, ON
ABS_IN ABS Status In OFF, ON
BOO_ABS Brake Pedal Position Switch Input OFF, ON
VLV_CTR ABS Valve Control Relay OFF, ON
LIMITSIG Limit Signals OFF, ON
MOTORLYI ABS Pump Motor Relay Input OFF, ON
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.