Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercury Villager BaseFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Air Bag Diagnostic Monitor | In Bottom Of Center Console |
| Air Bag Sliding Contact | In Steering Wheel |
| Anti-Lock Brake Control Module | Behind Center Of Dash |
| Battery Junction Box | In Engine Compartment, Next To Battery |
| Data Link Connector C2018 | Below Driver's Side Dash, Right Of Steering Column |
| Data Link Connector C252 | Below Driver's Side Dash, Left Of Steering Column, Above Fuse Junction Panel |
| Engine Compartment Relay Box | Left Front Side Of Engine Compartment |
| Fuse Junction Panel | Below Left Side Of Dash |
| Lighting Control Module | Bottom Of Center Console, Below Dash |
| Powertrain Control Module | Behind Glove Box |
| Smart Entry Control Timer/Module | Behind Center Top Of Dash Panel |
| Transaxle Control Module | Behind Instrument Cluster |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
