Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2000MYSTIQUE GS, 2.0 3, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESRELEARN PROCEDURESREMOTE KEYLESS ENTRY (RKE) TRANSMITTER PROGRAMMINGECONOLINE (TRANSMITTER WITHOUT ICONS)
2000 Mercury Mystique GS, 2.0 3, Automatic
Econoline (Transmitter Without Icons)
2000 Mercury Mystique GS, 2.0 3, AutomaticSECTION Econoline (Transmitter Without Icons)
- Turn ignition switch to RUN or ACC position. Using shorting pin, temporarily short terminals of RKE DLC together. RKE DLC is located at base of steering column. All doors should lock, then unlock.
- Press any button on transmitter(s). All doors should lock, then unlock to verify transmitter(s) have been programmed. If doors do not respond, press button again (3 times maximum) on same transmitter. If doors still do not respond, go to REMOTE KEYLESS ENTRY SYSTEMS - ECONOLINE article under ACCESSORIES & EQUIPMENT.
- Repeat procedure for additional transmitters (4 maximum). Turn ignition switch to OFF position. Remove shorting pin from RKE DLC. Very remote transmitters have been programmed by depressing LOCK and UNLOCK buttons and ensuring vehicle responds accordingly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.