2000 Mercury Cougar 2.0 3FACTORY OEM SERVICE PROCEDURE

Driver's Side

NOTE: There are 2 switches on driver's door panel. One for driver's side window and one for passenger's side window. This test is for both switches on driver's door panel.

Disconnect power window control switch harness connector (remove switch if necessary). Check continuity between control switch terminals with switch in appropriate position. See DRIVER'S SIDE POWER WINDOW CONTROL SWITCH CONTINUITYΒ  table. See Fig 1 . If continuity is not as specified, replace power window control switch.

DRIVER'S SIDE POWER WINDOW CONTROL SWITCH CONTINUITY

Switch Position Continuity Between Terminals No.
Down 1 & 3; 2 & 7
Neutral 1, 3 & 7
Up 1 & 2; 3 & 7
Fig 1: Identifying Driver's & Passenger's Power Window Control Switch Terminals
G99F08225Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.