Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Mercury Sable V6-3.0L DOHC VIN SFACTORY OEM SERVICE PROCEDURE
Removal and Replacement
Powertrain Control Module:
REMOVAL
1. Disconnect battery ground cable.
2. Remove cowl deflector.
3. Remove screw securing the ground cable of the engine control sensor wiring to the dash panel.
4. Loosen engine control sensor wiring to PCM connector retainer bolt.
5. Remove engine control sensor wiring from PCM.
6. Remove retaining nuts and powertrain control module insulator from dash panel.
7. Remove powertrain control module.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten insulator retaining nuts to 8-12 N.m (71-106 Lb-In).
3. Tighten engine control sensor wiring retainer bolt to 3.7 N.m (33 Lb-In).
4. Tighten engine control sensor wiring ground retaining screw securely.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
