Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Mercury Villager LSFACTORY OEM SERVICE PROCEDURE
Starter System Test
- Check Operation
Ensure battery is fully charged and in good condition. Ensure battery cables and connections are in good condition. Turn ignition switch to Start position. If engine cranks slowly, go to VOLTAGE DROP TEST. If engine does not crank, go to next step. - Check For Start Signal To Solenoid
Disconnect starter solenoid "S" terminal. See Figure . While holding ignition switch in Start position, measure voltage between "S" terminal (harness side) and ground. If battery voltage does not exist, go to next step. If battery voltage exists, go to SOLENOID TEST under BENCH TESTING. If solenoid is okay, replace starter motor. - Bypass Start Circuit
Connect one lead of remote starter switch to starter solenoid battery cable terminal. Connect other lead to "S" terminal on starter solenoid. Operate remote starter switch. If engine cranks normally, go to next step. If engine does not crank, repair or replace starter. If engine cranks sluggishly, recheck battery, engine ground and starter cables and connections. Repair or replace starter if battery, cables and connections are good. - Check TR Sensor
Check TR sensor, see TRANSMISSION RANGE (TR) SENSOR TESTΒ . Replace TR sensor if necessary. If TR sensor is okay, go to next step. - Check Voltage To TR Sensor
Turn ignition on. Measure voltage between ground and TR sensor harness connector terminal No. 4 (Light Green wire). See Figure . If battery voltage exists, restore electrical connections and go to next step. If battery voltage does not exist, repair open Light Green wire between fuse panel and TR sensor harness connector. Restore electrical connections and check system operation. - Check Power To Inhibit Relay
Turn ignition off. Ensure transmission is in Park. Remove inhibit relay located in left front engine compartment relay block. Turn ignition on. Measure voltage between ground and inhibit relay harness connector terminals No. 1 and 5. See Fig 1 . If battery voltage exists at both terminals, go to next step. If battery voltage does not exist at both terminals, repair open wire in question. See WIRING DIAGRAMS. - Check Relay Ground Circuit
Measure resistance of Black wire between ground and inhibit relay terminal No. 2. If resistance is less than 5 ohms, go to next step. If resistance is greater than 5 ohms, repair open ground wire (Black). Ground point is located at left front of engine compartment. Restore electrical connections and check system operation. - Check Red/White Wire
Measure resistance of Red/White wire between inhibit relay terminal No. 5 and starter motor harness connector. If resistance is greater than 5 ohms, repair open Red/White wire between inhibit relay and starter motor. If resistance is less than 5 ohms on models without anti-theft system, replace inhibit relay. Restore electrical connections and check system operation. On models equipped with anti-theft system, problem may be in anti-theft system. See ANTI-THEFT SYSTEM - ACTIVE article in ACCESSORIES & EQUIPMENT for testing procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
