Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Description & Operation
The switch monitor test uses PIDs to check the operation of certain switches (and related circuits) that do not set codes.
- 1) Turn ignition on. Connect NGS scan tool. See EQUIPMENT HOOKUP . Using NGS scan tool, select PCM and enter PID/DATA MONITOR AND RECORD function.
- 2) Select PIDs for switches in question. Operate switch while observing appropriate PID. If switch PID does not turn on and off when switch is operated, proceed with CIRCUIT TESTING.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.