Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
OBD-II System Readiness Tests
In some areas of the country, it may become a legal requirement to pass an Inspection/Maintenance (I/M) test of the OBD-II system. Before I/M testing can proceed, all of the System Readiness Tests (SRT) must show a YES status on scan tool. Follow scan tool manufacturers instructions.
During the mixed city and highway driving involved in the OBD-II drive cycle, the diagnostic test will test certain parts of the OBD-II software and hardware used to control vehicle emissions. Some tests will run to completion and will indicate a YES or NO, others such as misfire or fuel injection system test, will run continuously. See SRT STATUS .
| System Tested | Test Result |
|---|---|
| Misfire | Continuous |
| Fuel System | Continuous |
| Catalyst | No/Yes |
| Oxygen Sensor | No/Yes |
| Oxygen Sensor Heater | No/Yes |
| EVAP System | No/Yes |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.