Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Master Switch
Disconnect power window master switch. Using ohmmeter, measure resistance between indicated terminals with switch in specified position. See POWER WINDOW MASTER SWITCH RESISTANCE table. If switch resistance is not as specified, replace power window master switch.
| Switch & Position | Terminals No. | Resistance (Ohms) | |
|---|---|---|---|
| Left Window Switch | |||
| UP | 9 & 5 | Less Than 5 | |
| DOWN | 9 & 6 | Less Than 5 | |
| Right Window Switch | |||
| UP | 7 & 8 | Less Than 5 | |
| UP | 10 & 3 | Less Than 5 | |
| DOWN | 10 & 8 | Less Than 5 | |
| DOWN | 7 & 3 | Less Than 5 | |
| Lock-Out Switch (OFF) | 10 & 3 | Less Than 5 | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.