1996 Mercury Villager LSFACTORY OEM SERVICE PROCEDURE

Toe-In Adjustment

  1. Start engine. Center steering wheel. Secure steering wheel with holder and turn engine off. Loosen dust boot clamp (if equipped). Loosen tie rod end lock nut. Loosen steering gear dust boot clamp(s) at tie rod end. Turn tie rod end to obtain correct toe. See ALIGNMENT SPECIFICATIONSΒ  .
  2. Clean and lubricate lock nut and tie rod threads. Tighten lock nut to specification. See TORQUE SPECIFICATIONSΒ  . Ensure steering gear dust boot is straight after adjustment. Replace dust boot clamp.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.