Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1995 Mercury Villager LSFACTORY OEM SERVICE PROCEDURE

Steering Column: Description

All steering columns are energy-absorbing and collapse upon frontal impact. Vehicle is equipped with tilt steering wheel and air bag. A multifunction switch operates wiper/washer, turn signal/hazard and horn/dimmer. Multifunction and ignition switches are mounted on steering column.

WARNING: On models with Supplemental Restraint System (SRS), observe following precautions. Before any repairs are performed, disconnect and shield negative battery cable. Disconnect SRS connector at control unit. Use caution when working around steering column (air bag could deploy). For further information on air bags, see AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIPMENT section.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.