Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Mercury Villager LSFACTORY OEM SERVICE PROCEDURE
Master Switch
- Turn the ignition switch to OFF position.
- Disconnect the master window regulator control switch connector located on the left front door trim panel. Measure the resistance between the specified wire terminals on the master window regulator control switch. See MASTER WINDOW SWITCH TEST table. See Figure.
- If the master window regulator control switch does not operate as specified, replace the master window regulator control switch. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION.
MASTER WINDOW SWITCH TEST
| Control Switch | Switch Position | Test Between Terminals No. |
|---|---|---|
| Left | UP | 1-7 |
| Left | Neutral | 1-8 |
| Left | DOWN | 2-1, 2-8 &1-8 |
| Left | One-Touch | 3-2, 3-1, 3-8, 2-1, 2-8 &1-8 |
| Right | UP | 8-6 & 7-5 |
| Right | Neutral | 8-6, 8-5 & 6-5 |
| Right | DOWN | 8-5 & 7-6 |
| Lock | OFF | 8-6 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.