1995 Mercury Villager LSFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Circuit Breaker Behind Left Side Of Instrument Panel, Near Cowl Panel, Left Of Instrument Panel Fuse Block
Diode Junction Block Behind Top Left Side Of Instrument Panel, Taped To Main Wiring Harness
Instrument Fuse Panel Behind Instrument Panel, Left Of Steering Column
Left front Power Window Motor In Center Of Left Front Door
Master Window Control Switch Front Of Left Front Door, In Armrest
Power Window Module In Rear Of Left Front Door
Power Window Relay Behind Left Side Of Instrument Panel. See Figure.
Fig 1: Locating Power Window System Components (1 of 2)
G00097649Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.