Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Mercury Villager LSFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Control Module | Behind center of dash, mounted on center dash support bracket. See Figure . |
| Air Bag Diagnostic Module | Behind left side of dash. |
| Autolight Module | Behind top right side of dash. See Figure . |
| Daytime Running Lights (DRL) Module | On right side of engine bay, front of strut tower. See Figure . |
| Keyless Entry Module | Behind center of dash, mounted on center dash support bracket. See Figure . |
| Moon Roof Module | On right of moon roof motor. |
| Oil Level Module | Behind top right of dash. See Figure . |
| Passive Restraint Control Module | Behind center of dash, mounted on center dash support. See Figure . |
| Powertrain Control Module (PCM) | Behind right side of dash, behind glove box. |
| Power Antenna Module | Behind bottom of right kick panel. See Figure . |
| Power Door Lock Module | Behind center of dash, mounted on center dash support. See Figure . |
| Power Window Module | In rear of left front door. |
| Speed Control Module | Behind center of dash, mounted on center dash support bracket. See Figure . |
| Timer Module | Behind bottom of left kick panel. See Figure . |
| Transaxle Control Module (TCM) | Behind right side of dash, behind glove box. |
| Turn Signal/Flasher Module | Behind left side of dash, to right of steering column. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
